I have a Honeywell Quick Start Alarm Kit (Siren-based alarm). How do I link additional sensors to the Siren using the remote control key fob? Or how do I re-link existing sensors?

  1. Place the Siren into Service Mode by pressing and holding the ‘Disarm’ button ka_disarm on your remote control for 5 seconds. The Siren will produce 2 short beeps followed 1 second later by a single long beep. The Siren LEDs will flash together in conjunction with the beeps.
  2. Place the Siren into Learn Mode by pressing and holding the ‘Arm’ button ka_arm on your remote control for 5 seconds.
  3. The Siren will emit a single short beep and both the Comfort LEDs and the Learn LED will flash together slowly once every 2 seconds. The Siren will remain in Learn Mode for 30 seconds.
  4. To link a new wireless motion sensor, either remove the battery isolation tab from the sensor, or push the tamper button, located inside the battery compartment on the back of the sensor.

    ka_linking_a_new_motion_sensor_5 ka_linking_a_new_motion_sensor_6

  5. To link a new wireless door and window sensor, either remove the battery isolation tab from the sensor, or slide open and close the battery cover.

    ka_linking_new_magnetic_door_window_sensor_5 ka_linking_new_magnetic_door_window_sensor_6 ka_linking_new_magnetic_door_window_sensor_7